Harry M51, Инструкция по безопасности и эксплуатации

Страница: 12 / 24

HARRY
12
9 UNPACKAGING AND PREPARATION FOR
SETTING UP
Take the greatest care on unpacking the machine in order to avoid the
risk of danger to persons or things. The machine is packed in a box with
the driving plough tails lowered and the cutter unit disconnected.
10 CHECKS BEFORE STARTING UP
The drive plough tails can be adjusted in height and can also be positioned
sideways.
For height adjustment disconnect the fixture lever (re. A - fig. 6) and
position the plough tails to the required height, then lock the fixture lever
in position.
For sideways positioning release the plough tail unit using the click lever
(re. B - fig. 6), and then shift the plough tails to the right or the left, until
they match up with the relative hole, release the click lever so that the pin
enters the hole.
As the plough tails must be rotated by 180° in order to permit the use of
the motorized cultivator with other accessories (i.e. mowing bar), proceed
as follows:
1. remove the split pins which secure the control rods of the gear and
the pto, then remove the levers
2. release the plough tail unit by means of a special click lever, and
then rotate it by 180°
3. release the click lever so that the pin enters the relative hole
4. re-insert the rods securing them with the special split pins
11 APPLIANCE ASSEMBLY
For the assembly of the working appliance it is firstly necessary to press
the click lever of the snap couplings (re. A - fig. 7), insert the appliance
into the PTO, release the click lever and then gently shake the device in
order to facilitate its locking by means of the special pin.
12 CHECKS BEFORE STARTING UP
Before starting up check:
l the oil level in the engine and in the gearbox
l that there is fuel in the tank (see engine booklet)
l that the engine air filter is clean
l tyre pressure
l the tightness of the fixture screws and the regulation of the plough
tails and the hoe cutter
l clutch lever adjustment
13 STARTING UP
Before starting up:
1. position the PTO lever to idle
2. keeping the motorstop lever pressed lock the clutch lever by means
of the locking lever (re. B in fig. 3)
3. secure the wheel release lever using the special locking lever
4. position the accelerator lever at about a quarter of its stroke
Wear safety glasses to protect your eyes
Never smoke while filling the gasoline tank
Keep persons, who do not know the safety rules away from
the mower.
5. stand at the side of the machine being careful to keep out of the
danger zone (fig. 8)
6. grip the engine starter cord
7. pull firmly and release as soon as the engine starts
8. allow the engine to warm up for a few minutes before beginning
work
Fig. 6
Fig. 7
Fig. 8
danger
zone
A
B
A