Harris Platinum HT EL 2000LS, Техническое руководство

Страница: 21 / 90

must be filed promptly; otherwise, the carrier may not accept
the claim.
2.4.3
Factory Test Data Sheets
Factory test data is supplied with each transmitter. It lists pa-
rameters for operation of the transmitter. These readings were
recorded during factory testing. Locate the test data and place it
in the manual at the end of the maintenance section.
Record the same readings periodically to establish and maintain
an information base from which to work in the event of future
changes or problems.
FACTORY TEST DATA LOCATED
2.4.4
Cabinet Placement and Leveling
Four bolts hold the cabinet to its skid. They are located two per
side, front and rear. When the cabinet is in its final position, you
may need to level the cabinet. The HT EL cabinet has leveling
jacks in the corners to aid in leveling the cabinet on un-even
floors. The four 0.5 inch hold-downs in the bottom of the cabinet
used to bolt the cabinet to the shipping skid that may be used to
bolt the unit to the floor. Level the cabinet using shims under the
bottom, this is important to avoid deforming the cabinet when
bolting it to the floor.
Install the power module assembly in the bottom of the rack. It
will slide into mating electrical connectors. Install the Exciter(s)
and connect power and signal cables to exciter(s).
NOTE
DO NOT INSTALL RF MODULES AT THIS TIME
Figure 2-1. Transformer Taps
Section II - Installation
888-2457-001 2-3
WARNING: Disconnect primary power prior to servicing.