Harol TR850, Руководство по сборке

Страница: 13 / 16

- 13 - V3-10-10
Assembly instructions terrace awning TR850
G. Finishing & Maintenance
G.1. Finishing
If the sun blind is to be fitted with a storm bar, lower the drop bar by
about 15 cm. Remove the closing plate at the upper end of the guide
rails. Then take the storm bar supplied out of its packaging and carefully
press the runner down into the guide rails. Make sure the magnets are
pointing forwards and are able to touch the metal plate. The blind will
then run through under the storm bar. Refit the closing plate in the cor-
rect position. Then place a stop in the middle of the inside of the guide
rails at both ends.
This stop must catch the projection on the runner, but must always allow
the drop bar to pass. If the motor has been fully adjusted, the lid of
the casing can be replaced. For wide sun blinds an extra support is
provided in the middle of the casing to fasten the lid.
- If a number of sun blinds are placed next to each other it is advis-
able to connect the vertical guide rails together. For this, use the
connecting strips supplied, and clip them to the rails immediately
below the corner.
- To prevent sideways movement of the guide rails measures must be
taken to ensure lateral stability. Try to make a connection to some
other element which will provide lateral support, such as a wall or a
diagonal stiffener on the ground.
- To avoid entry of rain, run-offs can also be fitted under the guide
rails. These run-offs should be fitted using small plates with an M6 screw thread and suspension
brackets.
Important notice: please do apply the following guidelines very strictly!
1. Fix the suspension brackets to the bottom of the lateral guides ( 1 per 1,2m ).
2. Drill a hole through the gutter and the brackets with a diam. 3mm. Fix the gutter to the side of the
brackets with a parker-screw
3. Position the clip of the drainpipe between the lateral guides ( these clips are not included and can be
purchased at the DIY ). For an optimal fastening of the outlet basket, the axis of the pipe has to have
a spacing of exactly 28 mm. ( see fig.)
4. Attach the drainpipe to the clips ( the drainpipe is not included and can be purchased at the DIY ).
5. Install the outlet basket with its outlet opening into the drainpipe. Fix the outlet basket to backside
of the lateral guides with a screw and a small plate into the slot holes.
fig. 26: Magnets
fig. 27: Stop