- 11 -
V3-10-10
Assembly instructions terrace awning TR850
wires as shown in the diagram. The phase wire from the fuse box should be connected to terminal L.
If necessary, reverse the brown and black leads from the motor in the switch so that the arrows on the
switch correspond to rolling up and unrolling the sun blind
The two earth wires are jointly connected by means of separate wire clips and the same thing goes for
the two neutral wires.
E.2. Setting of the motor limit switches
Important notice about the motor: if the motor is a standard
type SLT-motor, you can carry on using this manual. If the
motor is an Orea or Altus – motor, you must consult the
manual of this very type of motor.
E.2.1 Roll-down direction - setting of the end position down
Let the motor run down. Make sure it stops in time (before
reaching the end pulley for the lateral guide). The motor has
no settings and runs free.
Both control buttons at the motor head have been pushed in
(push them in if they haven’t been) Both buttons pushed in
means the motor won’t stop by itself.
Let the awning unroll until you have reached the desired
end position. Turn the switch of the test cable into its zero-
position. Now you push the white or the yellow button
on the motor head (depending on whether the motor is
built-in on the left or the right side), so that the button
pushed comes up.
The end position down is now set .
E.2.2. Roll-up direction - setting of the end position up
Let the awning roll up and stop it by using the limit
switch, at a distance of about 10 – 15cm before the casing.
Make sure the bottom lath runs up straight (check the
squareness of the guide rails with respect to the casing if
it doesn’t). Push the blue button at the motor head and
make it will come up.
Let the motor run down again (about 10 – 15 cm), stop
it and then roll up and close the awning. Having done
this the motor will hum on for a couple of seconds more
(this in order to anticipate a possible later stretch of the
fabric). The end switches and end positions of the motor
are set now.
In case you have to reset the motor, you can repeat the
procedure by pushing in both buttons at the motor head.
By doing this you delete the existing end settings and
you can proceed from E.2.1. on.
fig. 22
fig. 24: roll-up direction
fig. 23: roll-down direction
Содержание TR850
Страница 1: ...Assembly instructions Terrace awning TR850 art nr 6837...
Страница 16: ......