Harmar Mobility HIGHLANDER II, Инструкция по установке и обслуживанию

Страница: 15 / 44

HIGHLANDER II VERTICAL PLATFORM LIFTS:
Install Manual
17FEB2021 | 630-00113 REV C
15
INSTALLATION
HIGHLANDER II: SECTION 4
INSTALLING THE PLATFORM
FRONT GUARD PANEL
Insert the front guard panel posts into the pockets
on the platform with the smooth side facing the
inside of the platform. Fasten in place with four (4)
1/4
"
-20 x 2
"
bolts.
If an auto fold ramp option is being installed the
ramp brackets must be installed with this hardware.
INSTALLING THE
AUTO-FOLDING RAMP
1. Attach the two ramp pivot tabs to the lower
landing sides of the platform using three (3)
¼
"
-20 x 2
"
bolts that go through the guard
panel post, and thread into the platform.
NOTE: If a platform gate is equipped, the pivot tabs mount
to the face of the gate with different hardware and nuts.
2. Assemble the ramp roller arm into the
rectangular pocket of the ramp with the
provided hardware. See Figure 4-7.
Ramp
Pivot Tabs
Rectangular
Pocket
Roller Arm
Figure 4-7
3. Use shoulder bolts to attach the ramp to the
pivot tabs.
4. To install the ramp roller guide, remove the
inside top and bottom side panel screws.
See Figure 4-8.
Screw
Curved corner of
ramp roller guide
UP
Screw
Figure 4-8
5. Install the ramp roller guide on the side of
the tower with the screw that was previously
removed.
NOTE: The curved corner of the ramp roller guide is
oriented up. For taller towers, the ramp roller guide has
three (3) mounting points.