Acendo BookInstallation
Acendo Book Scheduling Touch Panels - Instruction Manual
17
Locking Tab
Tab
ing Tab screws (x4) -
ten to extend each of
the four Locking Tabs
max torque = 5 IN-LB)
(front)
NOTE:
Consider making the actual cutout opening slightly smaller than the provided dimensions. This provides a margin of
error if the opening needs to be expanded. Too little wall material removed is always better than too much.
2.
Thread the incoming cables (Ethernet and Micro-USB) from their terminal locations through the surface opening,
leaving enough slack in the wiring to accommodate any re-positioning of the panel.
3.
Remove the Backbox knockouts and thread incoming cables through the knockout holes.
4.
Gently push the Backbox into the mounting surface.
This Backbox uses two Locking Tabs to secure the Backbox to the wall. For typical mounting surfaces, such as drywall,
the locking tabs are the primary method for securing the Backbox to the wall.
To ensure a stable installation, the thickness of the wall material must be a minimum of .50 inches (1.27cm) and a
maximum of .875 inches (2.22cm). The mounting surface should also be smooth and flat. For thin walls or solid
surfaces, use mounting screws (not included) - see FIG. 8.
5.
Extend the Locking Tabs by tightening the Locking Tab screws until snug.
FIG. 12 and FIG. 13 show the Locking Tabs on the ACB-2110 and ACB-2107
Backboxes:
Locking Tab
Locking Tab
Locking Tab screws (x4) -
tighten to extend each of
the four Locking Tabs
(max torque = 5 IN-LB)
Locking Tab
(front)
(rear)
Locking Tab
FIG. 12
ACB-2110 Backbox - Locking tab and locking tab screws (X4)
Locking
Lock
tigh
(
FIG. 13
ACB-2107 Backbox - Locking tab and locking tab screws (X2)
CAUTION:
The maximum recommended torque to screw in the locking tabs on the plastic Backbox is 5 IN-LB [56 N-CM].
Excessive torque on the tab screws can strip out the locking tabs or damage the Backbox.
Extend the Locking Tabs only AFTER the Backbox is inserted into the wall.
When installing the Backbox, make sure that it is positioned correctly.
The Backbox is clear to allow visual confirmation that the tabs have been extended and are gripping the wall, as well as
in assisting with removal if necessary.
(rear)
