Harbor Freight Tools Central Machinery 93762, Руководство пользователя и инструкции по безопасности

Страница: 18 / 28

Page 18 For technical questions, please call 1-888-866-5797. Item 93762
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
General Operating Instructions
Vertical position
WARNING! Always wear ANSI-approved safety
impact eye goggles when operating the Band Saw.
1.
Do not plug the power cord into an
electrical outlet until all necessary
adjustments (as previously discussed
in this manual) have been made.
2. Remove the Locking Pin (116) from the Pivot (121).
3. Raise the Body Frame (62) to its full vertical
position, as described in ″To Convert the
Band Saw for Vertical Use″ on page 11.
4. Turn the Support Plate (154) clockwise
until it firmly locks into the Body Frame and
insert the Locking Pin (158) to lock Body
Frame in position (see Figure V) .
Saw Blade (83)
power Switch (169)
Body
Frame (62)
Support
plate (154)
Locking
pin (158)
Locking
pin (116)
Figure V
5. Once all necessary adjustments to the Band Saw
have been made, plug the Power Cord2 (168) into
the nearest 120 volt, grounded, electrical outlet .
6. Turn the Power Switch (169) to its “ON” position.
cAUTION! Cut only flat workpieces when
the Band Saw is in its vertical position. Never
attempt to cut pipes or other round objects
with the Band Saw in its vertical position.
7. Before cutting, turn on the Band Saw and check
for excessively loose Saw Blade (83) tension
or machine vibration. Turn off the Band Saw
and correct any problems before using.
8. Set the workpiece on the Vertical Cutting
Table (197). Keep downward pressure on the
workpiece throughout the cutting process.
9. When cutting a large workpiece, make sure its entire
length is properly supported. If necessary, use a
roller stand (not included) with a larger workpiece.
10. Allow the Saw Blade to reach full speed before
feeding the workpiece into the Saw Blade.
WARNING! Keep hands and fingers
safely away from the cutting area.
11. Feed the workpiece into the Saw Blade
gradually. Do not force the Band Saw to remove
material faster than it is designed to cut.
12. Use two hands and hold workpiece
securely against table at all times.
WARNING!
Never attempt to remove material
stuck in the moving parts of the Band Saw while it is
plugged in and running. Turn off the Band Saw if the
workpiece is to be backed out of an uncompleted cut.
13. Once the cut is made, turn the Power
Switch (169) to its “OFF” position and unplug
the Power Cord from its electrical outlet.
14. Wait until the Saw Blade comes to a complete
stop. Then, remove the workpiece and scrap
material from the Vertical Cutting Table.
15. Remove the Locking Pin and turn the
Support Plate to the left. Then, lower the
Body Frame to its horizontal position.
16. Clean, lock in the horizontal position by
inserting the Locking Pin (116) into the
Pivot (121) (see Figure W) , then store the
tool indoors out of children’s reach.
pivot (121)
Locking
pin (116)
Figure W