Harbor Freight Tools Central Machinery 93762, Руководство пользователя и инструкции по безопасности

Страница: 8 / 28

Page 8 For technical questions, please call 1-888-866-5797. Item 93762
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
Setup - Before Use:
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Turn the power Switch of the tool off and unplug the tool from its electrical outlet
before performing any procedure in this section.
NOTE: For additional information regarding the parts listed in the following
pages, refer to the Assembly Diagram near the end of this manual.
Assembly/Mounting
To Assemble the Stand
1. Insert the Pull Handle (182) into the two mounting
holes located in the upper section of one
Stand (183). Then secure the Pull Handle to the
Stand, using two Pins (181) (see Figure A) .
2. Attach one end of the Tool Plate (184) to the upper
section of one Stand (183), using two Screws (187),
two Flat Washers (186), and two Nuts (185) .
3. Attach the other end of the Tool Plate (184)
to the upper section of the remaining
Stand (183), using two Screws (187), two
Flat Washers (186), and two Nuts (185) .
Figure A
To Attach the Wheels to the Stand
1. Align the two mounting holes in the Wheel
Bracket (194) with the two mounting
holes located in the lower section of the
Stand without the Pull Handle.
2. Secure the Wheel Bracket to the Stand,
using two Bolts (191), two Spring
Washers (193), two Flat Washers (192), two
Flat Washers (189-1), and two Nuts (189)
.