Harbor Freight Tools Central Machinery 93762, Руководство пользователя и инструкции по безопасности

Страница: 9 / 28

Page 9 For technical questions, please call 1-888-866-5797. Item 93762
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
To Attach the Band Saw to the Stand
1. With assistance and an adequate lifting
device, carefully set the Band Saw on top of
the Stand assembly. Place the motor end
of the Saw at the wheeled end of the stand,
making sure the upper section of the Stand
fits outside the base of the Band Saw .
2. Align the threaded mounting holes in each
end at the base of the Band Saw with the
two mounting holes located at each end of
the Stand assembly
(see Figure B)
.
MOUNTING
HOLE
MOUNTING
HOLE
MOUNTING
HOLE
MOUNTING
HOLE
Figure B: Stand (Top View)
3. Secure the Band Saw to the Stand
assembly, using four Screws (61) and four
Spring Washers (60) (see Figure c) .
Screw (61)
Spring Washer (60)
Figure c
To Attach the Stock Stop Assembly
1. When mounted to the Band Saw, the
adjustable Stock Stop assembly is used to
make repetitive cuts of the same length.
2. To attach the Stock Stop (162), slide the
Shaft (163) into the mounting hole in the
Machine Bed (147), and secure the Shaft by
tightening the Set Screw (153) (see Figure D) .
3. Slide the Stock Stop onto the Shaft, and secure
by tightening the Socket Head Screw (161) .
Stock
Stop
(162)
Socket Head
Screw (161)
Shaft (163)
Set Screw (153)
Hand
Wheel
(180)
Figure D
To Attach the pulley cover
1. Position the Pulley Cover (75) over the
Worm Shaft (12) and Motor Shaft.
2. Align the mounting hole in the Pulley Cover with
the mounting hole in the Body Frame (62).
3. Secure the Pulley Cover to the Band
Saw, using one Screw (65) and one
Spring Washer (66) (see Figure E) .
pulley
cover (75)
Worm
Shaft (12)
Motor (82)
Body
Frame (62)
Screw (65)
Spring Washer (66)
Motor Shaft
Figure E