Page 15
For technical questions, please call 1-888-866-5797.
Item 93762
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
To Adjust the Blade Tracking
1. Remove the Locking Pin (116) from the Pivot (121).
2. Raise the Body Frame to its full vertical position.
Turn the Support Plate (154) to the right until
it firmly locks into the Body Frame (62) and
insert the Locking Pin (158) to lock Body Frame
into position
(see Figure I on page 11)
.
3. Remove the Screw (113) and Flat Washer (114) to
open the Blade Back Cover (115). Turn on the Band
Saw and examine the Upper Blade Wheel (41).
WARNING!
To avoid injury, keep
hands clear of turning blade.
4. The Saw Blade (83) is tracking properly when the
back of the Blade is just touching the edge of the
Upper Blade Wheel flange. The back of the Blade
should not rub against the flange
(see Figure R)
.
Upper Blade
Wheel (41)
Blade
(83)
Wheel Flange
Figure R
NOTE:
If adjustment is necessary, the Blade Guide
Bearings (90, 94, 103, 107) should be completely clear
of the Saw Blade (83)
(see Figure Q on page 14)
.
5. Turn off the Band Saw and loosen the
middle Bolt (24) to a point where it is
loose but snug
(see Figure S)
.
Bolt (24)
Bolt (25)
Blade Tension
Adjusting Knob
(37)
Figure S
6. With the Band Saw running, turn the lower
Bolt (25) until the Saw Blade tracks properly.
Make sure Blade tension is maintained by
turning the Blade Tension Adjusting Knob (37).
7. When adjustment is complete, turn off the
Band Saw and re-tighten the middle Bolt.
8. Close the Blade Back Cover and secure
with the Screw and Flat Washer.
Содержание Central Machinery 93762
Страница 1: ......
