HappyJapan HCR3, Инструкция

Страница: 15 / 253

-R3 -12 2-7 PA21
2-7
SETTING UP THE MACHINE
Center support
If you embroider patterns dense in stitches like
wappen to the brim of border frame, front part
of border frame is pulled inside by shrinkage of
fabric and there is a chance that front part of
border frame bends as shown in Fig.1.
If front part of border frame bends, it causes off
registration.
If you embroider under such condition, please
fix center support in the center of border frame.
Please reverse procedure when remove the
table.
✽
If you fix center support in border frame,
neighboring area is reduced by 35mm as
shown.
If you misplace pattern, needle and presser
foot hit border frame and cause breakage.
Please pay care in this respect.
X-35mm
X
Center support
Set screw
(M4 x 10)
Center support
1. Spread fabric in border frame and
hold it with clips.
2. As shown in Fig. 3, fix center
support in the center of border
frame with set screws.
At this moment, long fixing hole
should face toward you.
Fig. 2
Fig. 3
Fig. 1