HappyJapan HCR3, Инструкция

Страница: 13 / 253

-R3 -10
Clamp
Fig. 5
Upper set screw
Table stay
2-6 P801
2-6
SETTING UP THE MACHINE
Assemble Removable table
and Border frame
1. Make sure that power source of the
machine is off.
2. Make sure that all Rotary hook
covers are shut.
If Rotary hook cover is not shut, the Table
will hit Rotary hook and damage it.
3. Remove middle set screw on Table
stay, extend Table stay as illustrated
in Fig. 1 and insert middle set screw.
4. As shown in Fig. 3, insert Removable
table in order of left, right and center
(last time).
As shown in Fig. 4, check rear edge
of the Removable table from bottom
and confirm that each table prop
plate are inserted and there is no
gap between Removable table and
Pre-fixed table.As shown in Fig.
2, fix set upper set screw on each
Table.
To prevent removable table from falling down, fix
screws immediately.
5. As shown in Fig. 5,6, shut all clamps.
6. As shown in Fig. 5, insert Table prop
B and tighten Knob bolts.
Tighten middle set screws which are
inserted as step 3.
7. Fix the Border frame under the
bracket of the X carriage and tighten
the Knob screw lightly.
Tighten Knob screw pulling Border
frame toward an arrow mark (to your
side).
Combination of table type and number of Clamp are depending
on model type.
Please reverse procedure when remove the Table and the Border
frame.
Fig. 7
Knob bolts
Table prop
Stopper
Border frame
Knob screw
Fig. 8
Fig. 1 Middle set screw
Removable table
Fig. 3
Fig. 2
Upper set
screw
5 1 2
3 4
Gap between Removable table
and Pre-fixed table
Fig. 4
Table prop plate
Fig. 6
Your side