HappyJapan HCR3, Инструкция

Страница: 10 / 253

-R3 -7
C
2-3 P801
2-3
SETTING UP THE MACHINE
for qualified personnel only
1. Please set four Casters to machine for easy
movement.
Each machine has the Caster suitable size for
the weight of the machine.
Please do not put Caster from different weight
machine.
2. Place Block base and Rubber mount under
bolts and adjust bolts so that the machine
becomes level.
Block bases and Rubber mounts are
included in accessories.
At this moment, get Caster slightly risen
from the floor.
As shown in Fig. 1, levelers should be
placed on both sides of Head bed with
Upper cover removed.
In case your machine has the center
adjusters, turn the adjuster until to touch the
Block base.
Check level of the machine again by Water
leveler at both ends of the Head bed.
Fix Pipe covers.
Pipe covers are included in accessories.
3. Remove Needle plates and Bobbin cases
from all the heads.
4. Please set main shaft position to C point
and pressing down the Needle holder by
your finger.
You can turn main shaft using by Six square
wrench of 4mm size turns in the direction of
the arrow.
5. Turn Main shaft by using the 5mm wrench
in direction shown with arrow mark and set
the angle of the Adjustment disk as shown
in Fig. 4.
Fig 2
L+10°
Fig. 3
Fig. 4
Fig. 1
Lock nut
Tighten
the lock nut
Lower Higher
Bolt
Pipe cover
Water level
Head bed
Block base
Rubber mount
Machine installation
Do not run the machine before setting it properly.
Make sure of taking the following steps to set the machine.
Adjustment
disk
針止め
Needle
holder
Caster
Lock nut
Tighten
the lock nut
Lower Higher
Adjuster