HappyJapan HCD3E, Инструкция

Страница: 7 / 362

-DA -8
SETTING UP THE MACHINE
2_1 S328
2-1
Assemble machine unit
1. Insert thread stand felt on the thread stand.
2. Turn the thread guide pillar clockwise with a
3 mm hexagonal driver until tight.
3. Install the thread guide bracket with supplied
screws (pan head screw M4 X 8 2 pcs).
4. Loosen the screw with a offset driver and
remove the red shipping collars that are
equipped on the both side of the guide bar.
(Keep the shipping collars. It is necessary
when packing.)
5. Raise slowly the control box to the front then
fix it with 2 screws (upper and lower).
6. Install the tubular frame arm for embroidery.
Please refer to (page 6-1) “Installing and
removing the tubular frame arm”.
Or, Install the cap frame for the cap
embroidery. Please refer to (page 7-1)
“Installing and removing the cap drive
frame”.
7. Insert built-in stylus into the holder (slot) of
control box.
When taking the machine apart in case
of packing, the process is opposite of
assembling the machine. Please do exactly
the opposite way of assembling.
When packing the machine up for
transportation, be sure to select the eighth
needle and fix it with shipping collars on the
both side of the guide bar.
1
2
3
Thread stand
felt
Thread guide pillar
Thread guide
5
Screw
4
Screw
Screws
Stylus
7