HappyJapan HCD3E, Инструкция

Страница: 10 / 362

-DA -11 2-4 Q701
2-4
SETTING UP THE MACHINE
Assemble safety sensor (Option)
Safety sensors are set at a provisional position
for transportation. Please reset the safety sen-
sors at normal positions for adjustment.
1. Unscrew set screws at lower points on the
safety sensors on right and left sides.
Loosen set screws slightly at upper points
on the safety sensors.
2. Set the right and left safety sensors at the
positions as shown in a photo by turning
them to the front side.
At this time, make sure the part on the
sensors indicated by an arrow shall be set
vertically, and set safety sensors both right
and left at parallel positions each other with
viewing them from the side.
The set screw on the right safety sensor
shall be tightened to the level that the
positions of the safety sensors can be
adjusted vertically.
3. Turn on the machine and confirm a lamp for
receiving ray (orange) is on when the way of
sensor ray is not blocked.
4. Confirm if the lamp for receiving ray (orange)
is turned off by blocking the way of sensor
ray by a hand or other.
Tighten the set screw firmly.
1
2
3
Set screw
Sensor left
Sensor right
Sensor right Sensor left
Ray receiver
Ray projector
Power indicator
Lamp for receiving ray
Power indicator
Way of sensor ray
4