HappyJapan HCD3E, Инструкция

Страница: 9 / 362

-DA -11 2-3 RC01
2-3
SETTING UP THE MACHINE
for qualified personnel only
3. Remove needle plates and bobbin cases
from all the heads.
4. Lower the needle holder by pressing down
with fingers on Fig. 4.
5. Turn main shaft by using the hexagonal
driver in direction shown with arrow mark on
Fig. 5 and set the angle of the adjustment
disk as shown in fig. 6.
6. Check the needle depth on all needles.
Pull white plastic f17 measuring gauge in
and out of rotary hook in fig. 7. If height
gauge brushes lightly against tip of needle,
needle height is correct. If not, loosen
needle bar block screw to adjust, then re-
tighten after adjustment.
(Remove the gauge when finished).
Note: Height gauge is contained in tool box.
7. Turn main shaft slightly in direction shown
by the arrow mark.
Then set the angle of adjustment disc as
shown in Fig. 8.
Note the space or timing between needle
and tip of rotary hook as shown Fig. 9, 10.
If the space is too open or too close, loosen
3 screws of shuttle to adjust. Make sure to
tighten 3 screws after adjusted the space.
(The timing is set exactly at the factory.
However, in some cases timing is
inadvertently thrown off from handling during
shipment.)
8. Turn main shaft in direction and set to C
point.
Place the bobbin and bobbin case in the
hook and replace the needle plate and
tighten.
9. Machine is now ready for sewing.
L+5°
L+23°
Fig. 10
Fig. 9
Fig. 8
Fig. 7
Fig. 6
Fig. 5
Fig. 4
針止め
Needle zholder
Screws
Needle
Tip of rotary hook
0.1~0.15mm
Head bed
0.1 ~ 0.2mm
Rotary hook
Needle
φ
17 Measuring gauge
Tip of rotary hook
Needle