Two post hydraulic lift HAPP 95
© 2013 HAPP Australia Pty Ltd
Version 9
Page
7
The standard lift version may not be installed and commissioned in the vicinity of explosives
or flammable liquids, outdoors or in moist rooms (e.g. car wash).
1.5 Safety Instructions for Operation
Read this operating manual especially section 8 of this manual.
Lift operation by authorized personnel over 18 years only.
Always keep the lift and lift area clean and free of tools, parts, debris etc.
Once the disk adapters contact the lift points, check arm restraints for engagement.
After raising the vehicle briefly, stop and check the disk adapters for secure contact.
Always lift the vehicle using all four adapters.
Make sure the vehicle doors are closed during raising and lowering cycles.
Closely watch the vehicle and the lift during raising and lowering cycles.
Do not allow anyone to stay in lift area during raising and lowering cycles.
Do not allow anyone on lift or inside raised vehicle.
Only use the lift for its intended purpose.
Comply with the applicable accident prevention regulations.
Do not overload the lift. The rated load capacity is indicated on the lift nameplate.
Only use the vehicle manufacturer’s recommended lift points.
After positioning the vehicle apply the parking brake.
Use caution when removing or installing heavy components (center-of-gravity displacement).
The main switch serves as emergency switch. In case of emergency turn to OFF position.
Protect all parts of the electrical equipment from humidity and moisture.
Protect the lift against unauthorized usage by padlocking the main switch.
1.6 Safety Instructions for Servicing
Maintenance or repair work by authorized service personnel only.
Turn off and padlock the main switch before doing any maintenance, or repair work.
Work on pulse generators or proximity switches by authorized service personnel only.
Work on the electrical equipment by certified electricians only.
Ensure that ecologically harmful substances are disposed of only in accordance with the
appropriate regulations.
Do not use high pressure/steam jet cleaners or caustic cleaning agents.
Risk of damage!
Do not replace or override the safety devices.
1.7 Safety Features
1.7.1 Hold-to-run Type Control
The operator is required to hold the controls in the engaged position to raise or lower the lift.
1.7.2 Equalizing System
The lift is provided with distributing and connecting flow valve to ensure level movement of both
carriages. Section 8 of this manual describes how to manage this system.
