Two post hydraulic lift HAPP 95
© 2013 HAPP Australia Pty Ltd
Version 9
Page
15
Raise vehicle to contact pads, recheck that pads are in contact manufacturers lift points and arm locks are
engaged.
Continually check for balance and rigidity of vehicle on hoist before lifting to operating height.
Raise:
•
Ensure all personnel are clear of hoist
•
Push green button to raise
•
Push hydraulic release lever to lower
until safety latches engage
before commencing work
Lower:
•
Ensure all personnel are clear of hoist
•
Push green button to raise slightly
•
Disengage safety latches on each column per operator’s manual
•
Push hydraulic release lever to lower
Before working at any position ensure the raise procedure is followed and safety latches /arm locks are engaged
on all columns.
5.1.3 Maintenance
Follow the HAPP user guides for regular planned maintenance. Ensure checks by competent persons are
performed at regular intervals or in the event of any accidental damage.
Isolate electrical circuits before performing maintenance procedures.
Change oil every 6 months, check for any cloudiness, which indicates water in oil, which causes rust.
Hydraulic oil:
Castrol HYSPIN 68 grade hydraulic oil is recommended for this hoist.
Environment:
This hoist is not designed to be operated outside or for steam cleaning or high moisture / harsh environments.
Vehicle hoists installed in such environments are not covered by HAPP warranty.
This hoist design is not registered for business use. Only HAPP hoist models that are registered with HAPP and
Workplace Health and Safety are to be used in business premises. In these locations the HAPP design registration
label will be affixed to the hoist and supporting documentation is to be held on the business premises.
This document does not relieve the owner / operator of its legal responsibilities in accordance with the
Workplace Health and Safety Act 2011.
