29
11)
Close the engine,retract all cylinder
pole,check the oil level of hydrualic
oil box.Add oil at graduation
position.
5.Change hydraulic transmission oil
Refer to ‘Change hydraulic transmission
oil’ from ‘Maintain monthly’.
6. Check, clean, change fuel filter
Note:
In the dust and dirty work condition,
clean fuel filters per one month and
changes per six months.
1. Take out the fuel filter discreteness.
2. Take out transducer form it.
3. Before install new one, install
transducer discreteness existing, put a
little fuel on the filter airproof.
Note
Before install, prohibit add fuel to filter,
otherwise accelerate the abrasion of fuel
system parts.
4
Install new filter discreteness.
5
Turn the new filter till the airproof
mat adhibit to surface.
6
Screw down 2/3 loops.
Maintain annually (2000 hours)
Increase the below content base on
maintain semiannually.
1.
Replace the engine cooling fluid
1
）
.Open the radiator cover and loosen
the drain cover, let the oil flow out, then
wash the cooling system.
2
）
. Screw down the drain cover.
3
）
. Add cooling fluid to radiator up to
way out.
4
）
. Let the engine run fully.
5
）
. Stop the engine, after cool down fully,
still add cooling fluid to radiator up to
way out, and add cooling fluid to coolant
reservoir “MAX” position.
6
）
.Check the drain cover if leakage.
△
!
Warning
！
When the water temperature of the
engine higher than 70 degree, please do
not open the pressure cap of the radiator
avoiding scald.
The
engine cooling fluid is prevent rust
and frostbite. See
《
Table for the oil used
in the truck
》
2.Front-wheel bear change lubricate
grease
Referrence<<Maintain manual>>drive
wheel hub,dismantle wheel hub.
3. Front-wheel bear change lubricate
grease
Referrence
《
Maintain manual
》
steering
axle content.
4.Change steering axle gear oil
Let the truck at level ground. At neutral,
engine flameout.
1. Take out the oil plug, put oil to a case.
Clean oil plug.
2. Install oil plug.
3. Take out breathe freely plug and oil
fluid position plug. Put the oil from orifice
bend to steering axle shell until oil
overflow from level plug. See add mete
anew.
4. Press level and bend plug.
5. Start-up forklift. Movement the engine
let the steering wheel control handle at
neutral.
6. Take out level plug. Keep oil level until
overflow.
