97
15. Use, installation and safety rules of attachment
HANGCHA will choose attachment that according with International standard
ISO2328
《
Forklift pothook fork and install size of carriage
》
,such as clamp, rotator,
paper roll clamp, carrying ram, side-shifter etc.
1
、
Attachment use.
（
1
）
Know well the content of nameplate on attachment, read the instruction
manual before
Usage.(Especially the manual from attachment company)Before operate the
attachment, the people should be trained and obtain the qualification.
（
2
）
It should be understand the basic capability and operate methods of
attachment. Especially the admit load, lift height, size of cargo and adapt range of
attachment.
（
3
）
Operate the multi-functional attachment, such as with side-shifter, clamp or
rotator, it is not allowed that two action at one time. Operate one functional then do
another one.
（
4
）
Prohibit the cargo at a high position when truck move with attachment. If
the size of cargo is too big, prohibit the truck move on. Transport the cargo, make sure
that the distance of bottom of cargo and ground is less than 300mm and mast incline
back.
（
5
）
The weight of cargo couldn’t exceed the limited value of combination
carrying capacity of forklift and attachment. It is not allowed that partial load at high
position. It is a short time work for attachment with side-shifter. Partial load is
around 100mm (Above 5 ton (including 5 ton), the side-shifter movable within
300mm.
（
6
）
In the range of the projection forth 2m of the lower of attachment and cargo,
prohibit stand to avoid the suddenness except the driver position under overhead.
（
7
）
It is not allowed that an emergency brake in moving. Run slowly with load.
（
8
）
Prohibit outside force when attachment working.
（
9
）
It couldn’t be use at malfeasance situation and overstep normal work range
（
10
）
When the attachment failure, prohibit use without check.
Check and maintenance:
（
1
）
Check the clearance of carriage beam and below catch of attachment if
accord the attachment manual.
（
2
）
Check the rise catch is right on the flute of fork carriage.
（
3
）
Use the auto currency lithic-grease per 500 hours to bearing surface.
（
4
）
If the tighten firmware become flexible.
（
5
）
Check the tie-in of hydraulic pressure loop, if tube attaint. Prohibit use after
