21
Step 1.
Install the axles in the landing gear as shown and
secure in place using an adjustable wrench.
Note:
A plywood mounting plate is glued in place inside the
wheel pants for mounting the pant to the landing gear.
Step 2.
Mark the position on the wheel pant where the axle will
pass through on the plywood side. It’s helpful to hold the wheel
in place over the wheel pant to judge the correct position. Mark
the position on both pants with a pen, being sure to mark on the
same side that the plywood plate is installed.
Step 3.
Drill a
1
/
2
" hole at the marked position on the wheel
pants. Be careful when drilling through the backside of the
plywood plate as it’s easy to split through the wood. It may be
easier to drill a smaller hole first, then progressively increase to
a larger bit size.
Section 8: Installing the Landing Gear
• Aluminum landing gear
• Fuselage
• (2) wheel pants
• (2) 4-40 x 5/8" socket head screws
• (2) 4-40 blind nuts
• (4) 10-32 x 1" landing gear mounting screws
• (4) 10-32 nuts
• (2) #4 split washers
• (2) #4 washers
Included in optional Hangar 9 Hardware Package
• (2) 3
1
/
2
" Wheels (DUB350TL)
• (2)
3
/
16
" x 2" Axles (DUB249)
• (4)
3
/
16
" Wheel Collars (DUB141)
• Drill with
1
/
8
" and
1
/
2
" drill bits
•
5
/
32
" and
1
/
8
" Hex Wrenches
• Adjustable wrench
• Pen
• Blue Locktite
®
Parts Needed
Tools and Adhesives Needed