15
Required Parts
• Wing panel (left and right) • Wing tube
• Clear tape
Note
: The following covers the assembly of
the wing without the use of glue. The wing,
when joined in this method, is very strong
and does not need to be glued together. You
will want to purchase additional clear tape
if you plan on breaking the wing down into
two pieces for transportation purposes.
Step 1
Slide the wing tube into the wing panel as shown. The
wing tube will only slide in halfway, so do not force it in
any further than it will slide easily.
Step 2
Slide the remaining wing panel onto the wing tube.
Step 3
As you slide the wing panels together, make sure the
aluminum pin at the back (trailing edge) of the wing
slides into the hole of the receiving wing panel. Slide
the two wing panels tightly together so there is no gap
between the two.
Step 4
Use the supplied clear tape to secure the joint between the
two wing panels. Make sure to apply the tape to both the
top and bottom of the joint.
Section 5: Wing Assembly
12843.1_HAN_Alpha40_SpektrumManual.indd 15
6/4/10 10:18:09 AM