H&S 9117, Руководство оператора, Страница: 39 / 56

LUBRICATION
GENERAL INFORMATION
IMPORTANT:
The Mixer must be properly lubricated, the gearbox and oil reservoir must be filled to the
proper oil levels before it can be operated.
IMPORTANT:
Catch and dispose of fluid per local waste disposal regulations whenever service is performed
on hydraulic components (valves, cylinders, hoses, etc.) or gearbox.
GEARBOX OIL LEVEL
NOTE:
Check the fluid level in the mixer gearbox periodically by removing the plug located on the
transmission. Requirements: 1-1/2 U.S. Pints (0.7 liters) of SAE #140 Gear Lube.
Check the gearbox occasionally for oil drips and dust accumulation around the seals. Oil drips or dust
accumulation indicate that seals are leaking.
Water is present in the oil if the oil is tan in color and foams excessively. Drain and replace the lubricant
immediately.
NOTE:
Fill the transmission gearbox to the bottom of the inspection plug hole - Do not overfill!
OILING
The chains on the Mixer should be lubricated every 15-20 loads using a good grade of lubricant. Spray
the entire chain on the center of the rollers.
OIL RESERVOIR
Check the oil reservoir daily. Oil level should be between Max/Min level marks. Fill as needed using
Exxon Nuto H46 or Equivalent.
GREASE
Use an S.A.E. multi-purpose high temperature grease with extreme pressure (EP) performance. An S.A.E.
multi-purpose lithium base grease is also acceptable.
1. Use only a hand-held grease gun for all greasing.
2.
Wipe grease fittings with a clean cloth before greasing to avoid injecting dirt and grit.
3. Replace and repair broken fittings immediately.
4. If a fitting will not take grease, remove and clean thoroughly. Clean the lubricant passage-way also.
Replace fittings as necessary.
-37-
Annually disassemble and clean parts in a solvent. Pack bearings
with a high grade grease. Reassemble, and tighten nut until a slight
drag is felt when wheel is turned. Back nut off and insert cotter pin
into first hole that you see as you back the nut off, bend cotter pin
over and reinstall cap.
WHEEL BEARING LUBRICATION, CLEAN & RE-PACK INSTRUCTIONS
Grease wheel bearings as needed through the zerks on each wheel hub depending on amount of
travel .