![background image](http://html2.mh-extra.com/html/hands/9117/9117_operators-manual_3051652028.webp)
UNPLUGGING
IMPORTANT:
When plugging is detected, stop mixer operation.
Mill, Mill Drive and Mixing Tank
Overfeeding of the mill and/or the mill inlet can result in plugging, thus slipping of the miller/blower drive
belt, or shearing the main shear bolt. Abnormal crop conditions would include crops with high moisture
content or crops that are too light or bulky which would not feed properly.
Overfeeding
If plugging develops from overfeeding, the tractor will choke down and even stall. To remove the plugging,
proceed as follows:
1. Shut the tractor off, remove key, disengage the PTO, detach the PTO and hydraulic hoses from
the tractor.
2. Shut off the feeder attachment (if applicable).
3. Open the mill screen cover, remove the screen and allow the material to fall down into the
transfer auger or remove material if the transfer auger is overloaded. Close mill cover.
4. Disengage the mill/blower drive sheave pin.
5. Start the tractor and engage the PTO at slow speed to convey the material into the Tank.
6. Shut the tractor off and disengage the PTO.
7. Open the mill screen cover, replace the mill screen, close mill cover, engage the mill/blower
drive sheave pin, and restart the tractor and PTO.
8. Bring the mill up to proper running speed and restart the feeder attachment (if applicable). If the
condition of the crop remains the same, reduce the feeding speed to avoid overfeeding.
OPERATION
-26-
MILL/BLOWER DRIVE BELT SLIPPAGE
Overload protection for the mill and blower components is provided
by an 8 “A” section drive belt, which connects the mill/blower driven
sheave to the drive sheave. The mill and blower will gradually slow
down without much reduction in tractor PTO speed if plugging
develops from mill/blower drive belt slippage. Stop turning the mill/
blower drive shaft if plugging or breakdown occurs in the mill or
blower areas. Follow steps 1 through 5 from OVERFEEDING to
remove the plugging. After the plugging has been remov
ed, shut
the tractor off, disengage the PTO, and adjust the drive belt tension
to the proper tension (see Adjustment Chapter). Restart the tractor
and PTO, bring the mill cylinder up to proper operating speed and
resume grinding.
IMPORTANT:
Stop mixer operation if drive belt slipping is detected.
Содержание 9117
