H&S 9117, Руководство оператора

Страница: 37 / 56

SERVICE
-35-
UNLOADING AUGER
If the Unloading Auger System becomes plugged, proceed as follows:
1.
Disengage the PTO, shut-off tractor and remove key.
2. Shut the unload auger door and turn off the on/off control valve to the OFF position.
3. Remove the clean-out cover on the vertical unloading auger, and the end cover/bearing on the
lower horizontal auger. Remove as much material as possible.
4. Replace the end cover/bearing on the lower horizontal auger, and the vertical unloading auger
cleanout cover.
5. Hydraulically lower the main discharge auger to the lowest position.
6. Re-open the flow control valve for the lower auger keeping the discharge auger unloading door
closed.
7. Re-start the tractor, engage the PTO, and turn on the on/off control valve to clear the remaining
material from the discharge augers.
8. Open the discharge auger unloading door making sure that the hydraulic gauge pressure does
not exceed 2500 p.s.i.
NOTE:
If the plugging is due to an improperly attached extension, check and correct before attempting to
resume unloading.
TIRES & WHEELS
Check the Tire pressure after every 50 hours of operation. Tires should be inflated to 80 PSI (563 kpa).
Wheel lugs torque should also be checked after every 50 hours of operation and tightened to 90 ft.-lb
(124 Nm) torque.