HAMPTON BAY H27U-NG, Инструкция для владельца и по установке

Страница: 23 / 56

23
Hampton ® H27U-NG/H27U-LP Direct Vent Freestanding Gas Stove
installation
Flex Liner
Exhaust
Flue
A maximum
of two certified
joiner kits
may be used
per length.
#948-305 (35 ft)
Air Intake
Co-linear DV
Vertical Termination
Cap # 946-529
Co-Linear
Flex
Adapter
with Kit#
946-563
Outer
Pipe
with Kit#
946-563
Inner Pipe
Adapter
with Kit#
946-563
Vertical Terminations with Co-linear Flex System
for Residential & Manufactured Homes into
Masonry Fireplaces
The shaded area in the diagram shows the allowable vertical
terminations.
Note: Must remove 4 screws from stove collar
and rotate 130
o
to have collar facing straight back. Secure into
place with 4 screws.
Vertical Termination with Co-linear Flex System
This appliance is designed to be attached to
two 3" (76mm) co-linear aluminium flex running
the full length of the chimney. See the Venting
Arrangements chart below for minimum and
maximum flue lengths. See chart below for
minimum distances from roof. Periodically check
that the vent is unrestricted.
Masonry chimneys may take various contours which the flexible liner will accommodate. However, keep
the flexible liner as straight as possible
, avoid unnecessary bending.
The Air Intake pipe must be attached to the inlet air collar of the termination cap.
Straight Vertical Terminations
Required Parts:
Part # Description
946-529 Co-linear DV Vertical
Termination Cap
948-305 3" Flex - 35 ft.
946-563 Co-Axial to Co-Linear Adapter Kit
which contains the following:
Co-linear Flex Adapter (270-585)
Outer Pipe (946-257)
Inner Pipe Adapter (946-219)
Vent Restrictors
set at fully open,
Posiiton "A"
THE APPLIANCE MUST NOT BE
CONNECTED TO A CHIMNEY FLUE
SERVING A SEPARATE SOLID FUEL
BURNING APPLIANCE.
Alternate Approved Caps:
Part # Description
46DVA-HC Vertical Termination Cap
OR
46DVA-VCH High Wind Cap
46DVA-GK 3" Co-linear Adaptor with flashing