HAMPTON BAY H27U-NG, Инструкция для владельца и по установке

Страница: 13 / 56

13
Hampton ® H27U-NG/H27U-LP Direct Vent Freestanding Gas Stove
installation
Locating Your Gas Stove
When selecting a location for your stove, ensure
that the clearances listed above are met as well
as ensuring that there is adequate accessibility for
servicing and proper operation.
Manufactured Mobile Home
Additional Requirements
1)
Ensure that structural members are not cut or
weakened during installation.
2)
Ensure proper grounding using the #8 ground
lug provided.
3) Appliance must be anchored to the floor with
the supplied anchoring methods.
Combustion and Ventilation
Air
The combustion air from this appliance is drawn
from outside the building through the outer flue.
Extra provision for combustion air inside the
room is not required.
A) Cross Corner
B) Room Divider
C) Island
D) Flat on Wall
E) Flat on Wall Corner
F) Flush with Wall/Alcove
For Vent Termination requirements,
see "Exterior Vent Terminal Locations"
section.
Optional Fan Installation
Fan Kit Contains:
Qty. Description
1 Fan Assembly c/w green wire attached
1 Thermodisc
1 Power Cord
2 2-1/4" x 20 Hex Nut
1 Fan Speed Control
3 Clip Wire Holders
1) a) Remove the rear access panel on the back
of the stove by removing the 2 screws under
the rear panel.
Screw Screw
Lift Rear Panel off the 2 top bolts
Bolts
3) Remove the Top Control Panel Assembly by
removing the three screws.
b) Lift off the 2 bolts at the top.
Take care not to cut wires when lowering the
panel.
Nylon Plug
Fan Speed
Controller
4) Remove the nylon hole plug from the control
panel.
5)
Install the fan speed controller onto the control
panel and secure with nut and washer. Connect
the red and black wires from the wire harness to
speed controller.
NOTE: Speed control wires
must be in the down position when control
panel is in place.
7) Re-attach control panel with 3 screws, reversing
step 3.
6)
Push black knob onto speed control.
8)
Place the blower close to the base of the unit
and feed the 3 wires from the fan through the
opening of the base of the unit.
Opening
9) Connect the ground (green) wire to the gound
lug on either side of the unit.