Hammer K2 M, Перевод оригинальной инструкции по эксплуатации

Страница: 16 / 56

16
Adjustments and tool changes
NOTICE
Incorrectly adjusted distance between the saw blade and riving
knife
Material damage and possible malfunction with covered cuts.
− The gap between the riving knife and saw blade must be
between 3 and 8 mm.
− When carrying out covered cuts, the highest point of the riving
knife must be 0-2 mm below the highest point of the saw
blade.
Tool:
● Spanner 17 mm
1. Preparing the machine for a tool change.
⮫
Chapter 1.3.2 ‘Prepare to
change tooling’ on page 11
2. Loosen the clamping screw.
3. Move the riving knife so that there is, at any given point, a distance of 3 to
8 mm between the saw blade and the riving knife.
4. The marking on the riving knife must match the top edge of the machine
table at the max. cutting height (independently of the saw blade used).
5. When carrying out covered cuts, the highest point of the riving knife must be
0-2 mm below the highest point of the saw blade.
6.
WARNING Flying pieces
Severe injuries and damage to property.
● Minimum tightening torque of the clamping bolt: 25 Nm.
Tighten the clamping screw.