Hammer K2 M, Перевод оригинальной инструкции по эксплуатации

Страница: 31 / 56

31
K2 M - Part 2/2 Use
3 Crosscut fence
4 Slot in machine table
1. Take note of general procedures for permitted working methods.
2. Move the rip fence as far away as possible from the saw blade.
3. Attach the off-cut deflector to the machine in such a way that the sawed off
pieces do not collide with the rising part of the saw blade.
4. Slide the crosscut fence into the slot in the machine table.
5. Place the workpiece against the crosscut fence.
6. Switch the saw on.
7. Press the workpiece hard against the crosscut stop using both hands.
8. Feed the workpiece evenly past the saw blade, keeping your fingers balled
into a fist.
9. Pull the workpiece a few millimetres away from the saw blade and move the
crosscut fence into the initial position.
2.3.7 Crosscutting with the crosscut and rip fence
1
2
Fig. 27: Crosscutting using the rip fence
1 Saw blade front edge
2 Fence plate (guide)
1. Take note of general procedures for permitted working methods.
2. Adjust the rip fence to the desired position.
3. Set the fence plate (guide):
Pull back the fence plate (guide) and clamp them (see illustration).
🡆
The workpiece can not, as a result, become clamped in-between the
fence and the saw blade.
4. Slide the crosscut fence into the slot in the machine table.
5. Place the workpiece against the crosscut fence.
6. Switch the saw on.