75
X/2
X
X/2
X
Gefaket!!
15 mm in Richtung dimetrie 1 verschoben
Schiebetisch, Grundbahn, Handrad Logo
"
!
#
Saw-Spindle Moulder
B3 / B3 e-classic
10.5.10 Working with grooving tools
Fig. 10-15: Working with grooving tools
Fig. 10-16: Working with grooving tools
Warning: Risk of injury!
• Groove cuts may only be carried out with an overhead saw guard! Do not, under any circumstances,
use a saw blade guard (guard mounted onto splitter)!
• Do not pull the combination fence‘s guide back!
• Remove the splitter.
• Set the cutting angle to 90°.
1.
Take note of general procedures for authorised work-
ing techniques.
2.
Set the combination fence to the desired dimensions.
3.
Lock the sliding table into a centre position.
4.
Set the cutting height to a maximum of half the work-
piece thickness.
5.
Always use the crosscut fence and the sliding table
for transverse grooves (see „Cutting to length against
the parallel cutting fence“).
6.
When feeding the workpiece forward, press it hard
onto the sliding table.
Use an eccentric clamp if required. If an eccentric
clamp is used, shape the groove using the sliding
table.
Fasten Sawboy by means of the screw onto the parallel
fence, in the case of a thin-walled fence by means of
said screw and the nut.
Operating and adjusting:
Read individual operation instructions
!
Sawboy
"
Fence guide
#
Special-nut
Fig. 10-17: Auxiliary fence
Note: Tenoning hood and moulding guard „Sawboy“
see: Tools and Accessories catalogue
Operation
