71
!
"
§
$
Saw-Spindle Moulder
B3 / B3 e-classic
10.5.5 Trimming
1.
Take note of general procedures for authorised
working techniques.
2.
Assembling the trimming shoe:
• Thread the trimming shoe into the sliding table
grooves using locking plates.
• Clamp the trimming shoe onto the sliding table
using thumb screws.
3.
Undo the sliding table catch and pull the sliding ta-
ble back completely.
4.
Place the unfinished plank, with the hollow side fa-
cing downwards, onto the sliding table and clamp in
the trimming shoe.
5.
Switch on the circular saw.
6.
Feed the workpiece evenly past the circular saw, kee-
ping your fingers balled into a fist.
!
Thumb screws
"
Trimming shoe
§
Groove
$
Sliding table
Fig. 10-7: Trimming shoe
Operation
10.5.4 Longitudinal cut
1.
Take note of general procedures for authorised
working techniques.
2.
Set the rip fence to the desired measurement.
3.
Lock the sliding table into a centre position.
4.
Place the workpiece against the rip fence.
5.
Switch on the circular saw.
6.
Switch the scoring unit on, if necessary.
7.
Feed the workpiece evenly past the circular saw,
keeping your fingers balled into a fist.
Fig. 10-6: Longitudinal cut
