10
•
If a door leaf or window sticks out, the sensor can also
be attached at the side, and the device can be attached
flat on the frame.
Warning - Installation with adhesive pad
•
All parts are intended for indoor use only. Do not
install them outdoors.
•
Please note that the installation surface you choose
should be free of dust and grease. Use a suitable clean-
ing agent from a specialised dealer to clean the surface.
•
Note that the adhesive pad attachment is permanent.
To remove the adhesive pad, carefully pull it off the
installation surface.
•
Various environmental factors such as ambient
humidity, sunlight or cold can impair the durability of
the adhesive pad.
•
We cannot guarantee that residue will not be left on the
mounting surface after the adhesive pad is removed.
4.4.3 Integrating devices in the Hama Smart Solu-
tion app
Now insert the two AAA batteries supplied, observing
correct polarity. When you press the anti-theft protection,
the LED should briefly light up blue; if not, please replace
the batteries
Warning - Batteries
•
When inserting batteries, note the correct polarity (+
and - markings) and insert the batteries accordingly.
Failure to do so could result in the batteries leaking or
exploding.
•
Only use batteries (or rechargeable batteries) that
match the specified type.
•
Before you insert the batteries, clean the battery
contacts and the polar contacts.
•
Do not allow children to change batteries without
supervision.
•
Do not mix old and new batteries or batteries of a
different type or make.
•
Remove the batteries from products that are not being
used for an extended period (unless these are being
kept ready for an emergency).
•
Do not short-circuit batteries.
•
Do not charge batteries.
•
Do not throw batteries in a fire.
•
Keep batteries out of the reach of children.
•
Never open, damage or swallow batteries or allow
them to enter the environment. They can contain toxic,
environmentally harmful heavy metals.
•
Immediately remove and dispose of dead batteries
from the product.
•
Avoid storing, charging or using the device in extreme
temperatures and extremely low atmospheric pressure
(for example, at high altitudes).
•
Now press the Pairing button for 5 seconds. The LED
begins to flash red quickly. If it flashes slowly, press the
button again for 5 seconds.
•
Open the app and log in.
•
Press
+
in the upper-right corner to add a new device.
•
Select
Sensors
in the list and then select your device.
•
Now confirm that the LED flashes quickly.
