Halton Capture Jet KVE-WW, Руководство оператора

Страница: 21 / 30

21
Capture Jet
®
with Water Wash Operation & Maintenance Manual
OM-0
06/1
120
16/re
v2/EN
Wash Status Screen
The Wash Status screen allows the user to monitor the progress of each wash cycle. While the Wash, Soak, or Rinse
cycle is running the word ON appears in the field which is currently active. After the Wash, Soak, or Rinse cycles
completes, the word ON moves to the next field. Once the entire sequence for a given wash cycle has completed the
word DONE will appear in the DONE field for the cycle which has completed.
“Section” to the left of each row refers to an individual Water Wash hood section (or Duct Sump) that is to be washed.
The hoods are washed sequentially one at a time until all hoods (or Duct Sumps) have been washed. No control
functions are available on this screen
Wash Scheduler Screen
The Wash Scheduler screen allows the user to choose when the wash functions will take place. Both the day of the
week and the time of day must be selected for each set of wash cycles. When the software button corresponding to a
day of the week is depressed a wash cycle will be performed on that day. The hour selections are in 24 hour format. 12
in the hour box represents noon. 14 would represent 2 o’clock in the afternoon, 18 represents 6 o’clock in the evening,
etc. Input the desired wash cycle start time using the 24 hour format for the days of the week selected. The Use End
Time should be set 15 seconds later than the Start Time. This second setting (Use End Time) ensures the controller
will acquire the data signal, it is not intended to describe when the wash cycle ends. When this data has been entered
press the blue Update Setting button. The green Time Acquisition Complete light will illuminate if the process has been
successful. Press the Update Setting button again to complete the process. If the red Error Notification light illuminates
instead double check that the days selected in the Use End Time row are the same as in the Start Time row and that
the Use End Time input is set for at least 15 seconds after the Start Time input. The green Wash In Progress light will
illuminate during the wash cycle(s).
Note: The wash cycle is typically scheduled for times when the exhaust fan will be known to be off. If the exhaust fan is
ON when a wash cycle is scheduled to begin a message will appear on the home screen that will read “Wash Initiated –
Wash will start after fan stops”. This will not interrupt the hood usage if after hours cooking is taking place, for a special
occasion for instance. The controller will wait until the exhaust fan is manually turned off and then the wash process will
begin.
Note: There must be detergent in the detergent tank before the Wash Scheduler may be set up. An error message will
appear if this is not the case.