Instruction Manual PUC 28
18
5.2.9 Delete Re-Calibration [ SETTINGS / UNDO TEACH ]
Any re-calibration (positive as well as negative range) carried out after the delivery will be
called off (concerns only the variants PUC 28/K).
5.2.10 Reset the device [ SETTINGS / RESET ]
The PUC 28 will be resetted completely (this is equvalent switching off and on again the power
supply of the device). The Profibus interface (for devices with Profibus DP interface) is also
initialized. The menu settings stay unchanged.
5.2.11 Recall the delivery state [ SETTINGS / DELIVERY ST. ]
According the acual configured measurement range (±100 Pa or ±250 Pa) all menu settings
are reset to the delivery state and being saved. Subsequently the PUC 28 will be resetted
completely (this is equvalent switching off and on again the power supply of the device). The
Profibus interface (for devices with Profibus DP interface) will also be initialized.
5.3 Scaling and limits [ VALUES ]
The PUC 28 is adjusted for the sensors used and the limits set for the alarm signals in the
“VALUES” menu.
Resetting the device might for example be useful if a new address is being set with
the help of the both rotary switches. After the reset the new address is active.
