Hali-Brite SPS Series, Руководство по установке и обслуживанию

Страница: 25 / 26

SPS Installation and Maintenance Manual
25
6.6 Solar Panel Angle Adjustment
The angle of the solar panel is factory set for the installation location. No further
adjustment is necessary. However, if adjustment is required, proceed as follows:
1. Refer to Figure 14. A series of holes located in each of the two solar panel
side brackets are used to select the solar panel angle. The 5 holes in each
side bracket allow the elevation angle to be set to 25, 35, 45, 55 or 65
degrees above horizontal.
2. Determine the geographic latitude of the installation location.
3. The desired solar panel elevation angle is the latitude plus 15 degrees.
Figure 14. Solar Panel Angle Adjustment
4. Choose the mounting holes which will result in an elevation angle closest
to the desired elevation angle.
5. If it is necessary to change the angle, remove the bolt from each side
bracket, reposition the solar panel, reinstall the bolts, and tighten securely.
6.7 Photocell Replacement
4. Refer to Figure 15. The photocell is installed in a receptacle. Grasp the
photocell, rotate it 1/8 turn counter-clockwise, and pull it out of the
receptacle.
65 Degree Elevation
25 Degree Elevation