Hali-Brite SPS Series, Руководство по установке и обслуживанию

Страница: 22 / 26

22
SPS Installation and Maintenance Manual
Figure 11. Solar Panel Junction Box
5. Locate the solar panel junction box on the rear surface of the solar panel.
Remove the junction box cover, as shown in Figure 11.
6. Locate the black and white wires entering the junction box from the liquid-
tight conduit. Note their location on the terminal block, for later
reassembly. Remove the black and white wires from the terminal block.
7. Remove the liquid-tight conduit connector from the wall of the junction
box.
8. Remove the defective solar panel, and position the replacement solar
panel for reassembly.
9. Reassemble the liquid-tight connector to the wall of the solar panel
junction box.
10. Reattach the black and white wires to the terminal block as shown in
Figure 11.
11. Reinstall the cover on the solar panel junction box.
12. Attach the solar panel to the mounting brackets with the 4 mounting bolts,
and tighten securely.
13. Install the fuses, using the procedure described in Section 4.3.6.
14. Perform the electrical checkout as described in Section 4.3.7.
15. Reinstall the battery enclosure cover.
6.4 Charge Controller Replacement
Perform the following steps to replace the charge controller:
1. Note: The charge controller is custom-programmed by Hali-Brite
®
.
Do not install a controller purchased elsewhere, it will not operate
properly. Acquire a new charge controller before continuing this
procedure.
2. Install a temporary cover on the solar panel, to prevent battery charging.
3. Remove the battery enclosure cover, by reversing the procedure
described in Section 4.3.8.
4. Remove the battery fuses, by reversing the procedure described in
Section 4.3.6.
Liquid-tight conduit