Hali-Brite SPS Series, Руководство по установке и обслуживанию

Страница: 14 / 26

14
SPS Installation and Maintenance Manual
3. Remove the wire nut from the black wire, and use this wire nut to connect
this black wire to the black wire from the wind cone power cable.
4. Remove the wire nut from the red wire, and use this wire nut to connect
this red wire to the white wire from the wind cone power cable.
Figure 5. Power Cable Wiring
4.3.5 Install the Batteries
Proceed as follows to install the batteries:
1. Locate the battery connection wires and fuses (packed with this manual).
2. Caution-The fuses are not installed in the inline fuseholders. Do not
install the fuses until instructed to do so.
3. Unpack the batteries from their packing materials. Locate the battery
terminal bolts and washers, shipped with each battery.
4. Place the batteries in the battery enclosure, with the battery connection
posts towards the charge controller, as shown in Figure 6. The batteries
are installed as close as possible to the charge controller, snugly against
the battery stop in the floor of the battery enclosure.
5. The batteries are wired to the charge controller as described in the
following steps. Use the bolts supplied with the batteries, and loosely
hand-tighten the bolts as you make the connections. The battery bolts will
be tightened with a wrench after all the connections are in place.
RTS
Wire nuts connecting
wind cone power
cable to the SPS