Hali-Brite SPS Series, Руководство по установке и обслуживанию

Страница: 17 / 26

SPS Installation and Maintenance Manual
17
1. The SPS should now be operating. Locate the charge controller, as shown
in Figure 7.
2.
On the top surface of the charge controller, locate the three “Battery
Status” LEDs.
3. The Battery Status green LED will illuminate, indicating a full battery
charge, or the yellow LED will illuminate, indicating a partial charge. (A
partial charge is OK.)
4. Locate the
“Charging Status” LED on the top surface of the charge
controller.
5. The Charging Status LED should flash green briefly every 5 seconds. This
indicates the charging system is in Night Mode, since the solar panel is
still covered.
6. Inspect the wind cone light. If this installation is being done during the day,
with sufficient sunlight, the wind cone light should be off. If the wind cone
light is off, proceed to Step 8.
7. Note: If the wind cone light is on, it may be dark enough to cause the
system to be in Night Mode. Locate the green photocell on the side of the
battery enclosure. Shine a flashlight beam in the photocell light entrance,
to simulate normal daylight. If this causes the wind cone light to turn off, it
is too dark to perform these tests. Stop this test, and repeat it in normal
daylight.
8. Remove the protective cover from the solar panel. Assuming daylight is
available, the Charging Status LED will become steady green, and flash
off briefly every 5 seconds. This indicates the charging system is in Day
Mode, and the solar panel is charging the batteries.
9. Locate the green photocell mounted on the side of the battery enclosure.
10. The photocell has a light entrance opening in the side. Cover this entrance
to block light from entering the photocell. The wind cone light should turn
on.
11. Uncover the light entrance on the photocell. After a few seconds, the wind
cone light should turn off.
12. Check to be sure 1 fuse is installed for each battery, and that each
fuse is not blown. If good fuses are not installed for every battery,
the unit will operate, but will not have full battery capacity.
13. If the product performs as stated above, it is functioning correctly. If any of
the Status LEDs are red, or if the wind cone light does not function
correctly, contact Hali-Brite
®
for assistance.
4.3.8 Install Battery Enclosure Cover
Install the battery enclosure cover as follows:
1. Inspect the black weather seal around the top edge of the battery
enclosure, to make sure it was not damaged during this installation
process.