Using the Remote Control
MENU Items
Stingray
2 User’s Guide, v6.0, Issue 01
28
* Audio Settings
This menu is used to adjust the
System Volume
and
SAP Audio
settings.
•
System Volume
sets the master volume for all of the system sounds rather than the
volume of the television audio. It adjusts the volume of the user interface feedback
sounds that the system uses for button presses, error messages, etc.
The choices are OFF, LOW, MEDium, and HIGH. Use the arrow buttons to highlight
your preference; then press the OK button.
•
The
SAP Audio
menu enables you to turn on or turn off the Secondary Audio Program
(SAP). The SAP is the second audio channel (if available) that carries an alternate
language for the current show.
When SAP audio is available in the tuned channel and SAP is turned on, the STB will
play the secondary audio channel instead of the primary audio channel. When SAP is
enabled and SAP audio is available and playing, a small box with the letters “SAP” ap-
pears in the upper right hand corner of the GUIDE screen.
Press the left arrow to move back to the previous menu or the MENU button to exit
menus completely.
* Network Settings
CAUTION
This menu is intended for use by service providers or system administrators
only (rather than end-users).
A password is required to enter the Network Settings screen. This menu allows for setting
a DHCP or STATIC network configuration.
For a static configuration, a unique IP Address, Subnet Mask, Gateway, DNS1 and DNS2
must be supplied.
To set a DHCP dynamic configuration, select the DHCP option. The selected configuration
activates after power is removed and reapplied to the STB.
* Information
This screen shows system information and settings for the Stingray
2. Use the UP / DOWN
arrows to navigate through the screen. Press the left arrow to move back to the previous
menu or the MENU button to exit the menus completely.