Using the Remote Control
General Controls
Stingray
2 User’s Guide, v6.0, Issue 01
24
General Controls
POWER
After the STB is provisioned with its application, pressing the power button brings the STB
out of standby mode (green LED) or places it back in standby mode (red LED).
To use any of the other buttons below, the STB must have previously accepted its applica-
tion from the network and be out of standby mode. Pressing a remote control button flashes
the Stingray
2 LED to indicate reception.
HELP
This displays the Help menu that describes the functions of the various buttons on the
remote control. For example, press the GUIDE button and the Help system describes the
function of GUIDE button.
CHANNEL UP / DOWN
Use the CH (channel) + / - buttons to change channels. You can also change channels by
typing in the channel number on the remote control. The channel automatically changes
after a few seconds, or you can press ENTER after the channel number to make it change
immediately.
CH+ and CH- also act as page up and page down buttons when navigating the program
guide or menus.
VOLUME UP / DOWN
These buttons control the volume level of the audio provided to the television (i.e., rather
than affecting the volume level setting of the television). VOL+ increases the volume, and
the VOL- decreases the volume level.
MUTE
This silences (mutes) or un-silences (un-mutes) the audio output of the STB to the televi-
sion. The MUTE button does NOT change the value that is set for the television.
GUIDE
This displays the electronic program guide showing channel list and program lineup. If
available, it also lists Video on Demand (VoD) content.
To navigate the program guide, press the up or down ARROW buttons to traverse the guide
one entry at a time. Use the right ARROW or left ARROW buttons to move from the
channel lineup to the program list.
