vario flex
Installation
Order h49 7144.907-333
35
INFORMATION
For installation of a workpiece-specific limit stop, there
is a thread at the front. On the flat surface of the limit
stop near the supply bores, there must be a recess.
From this recess, the rinsing bores are directed for-
wards into the area where the workpiece gets rinsed.
7.5.3 Installation of the product on the clamping device
INFORMATION
Installation / removal of the product is described in the
operating instructions for the clamping device.
In addition to these operating instructions, also read
and follow the operating instructions for the relevant
clamping device.
INFORMATION
Before installation of the ejector, the base end-stop of
the clamping device must be removed.
INFORMATION
Pay attention to the following when using the adapter
disc as a rinsing connection / air system check:
The media supply on the machine must be
adapted to suit the length of the adapter disc.
The external diameter of the media supply unit
must be
12 ± 0,1 𝑚𝑚
.
1. Install the product.
