– 39 –
High Drain Loop Hose
Disconnect Turbidity Sensor Harness
8. Loosen the high drain loop hose clamp (1/4-
inch hex-head) and remove the hose from the
drain pump (there will be a small amount of
water in the sump, pump and hose).
9. Disconnect the turbidity sensor wiring (on
some models).
10. Unlatch three sump clips. All three latches
can be reached from the front of the
dishwasher in most installations. If the
dishwasher does not have the legs extended,
the dishwasher may have to be removed from
its installed position.
11. The sump latches below are shown in the
release position. Each latch has a stop point
built in. Turn the latches to a stop point when
unlatching and latching.
12. Push the sump from the bottom into the tub.
13. Grasp the sump from inside, using care NOT
and lift to bring the sump into the tub. Bring
access to disconnect the wiring in the next
step.
NOTE: It is important to route the wire
harnesses in the same locations to prevent
