Hagstrom KE-USB36, Руководство пользователя

Страница: 5 / 20

Connection to the Computer
The KE-USB36 attaches to your computer’s
USB port. Use a standard A-B Male/Male
type USB connecting cable from the KE-
USB36 to the USB port on the computer.
The KE-USB36 may be connected directly
to the USB port on the PC or through a
compliant USB Hub.
Connect the type “B” end of the USB cable
into the KE-USB36 and the type “A” end
into the PC or HUB USB connector.
The KE-USB36 may be connected to the computer with power
on or off. If “hot plugged,” the unit will generally take several
seconds to become fully
active on your system.
Note:
The first time you
use the KE-USB36 with
a particular PC, you will
be prompted to load the
appropriate drivers for the
device. Follow the default
selections to load the
standard drivers for the KE-
USB36.
The KE-USB36 is powered directly from the USB port, so no
external power is required.
The KE-USB36 is compatible with operating systems which offer
full support for USB devices compliant to USB 1.0 specifications.
Consult the operating system manufacturer for information on
device compatibility and downloads.
Figure 2
- Connection of
the USB cable to PC
Figure 3
- Connection of the USB cable to
KE-USB36
Appendix D:
Board ID
Two KE-USB36 devices may be connected to the same machine.
Each KE-USB36 unit has a two position jumper which may be used
to identify the unit as #0 (primary) or #1 (secondary). BoardID is
0 or 1 based on the 2 position jumper setting on the board. ID 0
= Jumper Open (default). This jumper is located near the middle
of the KE-USB36 board and is the only 2 position jumper on the
unit (see figure 15).
5 16
Figure 15
- Location of two position BoardID
jumper.