4-12
Step2
Connect one end of the RF cable to the feeder lightning arrester and the other end to the outdoor
antenna.
Step3
Wrap each joint with insulation tape first, and then with waterproof tape.
z
It is recommended to install a feeder lightning arrester on each antenna interface and ground it
well.
z
A finished RF cable with a fixed length can be shipped with the AP if ordered. If such an RF cable is
not long enough, you should provide a longer RF cable and an N-type RF connector and prepare
the cable at the site.
z
Distinguish the stickiness of the two sides of waterproof tape. Before wrapping a cable joint, stretch
the waterproof tape so that the width is three quarters of the original one to ensure the tightness.
Connecting an Ethernet cable
Follow the steps below to connect an Ethernet cable. Otherwise, the AP may get damaged
Step1
As shown in Figure 4-15, Figure 4-16 and Figure 4-17, route the waterproof Ethernet cable from the
equipment room to the AP installation location.
Figure 4-15
Connect the Ethernet electrical interface to the uplink device
AC
power
Power adaptor
Port lightning protector
Ethernet Cable
LAN switch
Grounding cable
AP
Antenna
RF coaxial
Indoor
Outdoor
