4-15
Pin of RJ-45
connector
Signal
Category-5 twisted pair
cable
Signal direction
Pin of RJ-45
connector
3 Rx+
White
(green)
Å
1
4 —
Blue
— 4
5 —
White
(blue)
— 5
6 Rx-
Green
Å
2
7 —
White
(brown)
— 7
8 —
Brown
— 8
z
When distinguishing or preparing these two types of Ethernet cables, you can refer to the above
tables. Since the Ethernet interface of the AP is auto-sensing, these two types of Ethernet cables
can be used for the Ethernet interface.
z
Refer to Table 4-1 and Table 4-2 to arrange the wire sequence when preparing an Ethernet cable.
Otherwise, the communication quality will not be high, even if the devices at both ends can
communicate.
z
The Ethernet cable should be equipped with a waterproof sheath when routed outdoors. If possible,
cable routing in waterproof tubes is recommended.
Step3
Insert the Ethernet cable connector into the Ethernet interface, as shown in Figure 4-19.
Figure 4-19
Insert the Ethernet cable connector into the Ethernet interface
Step4
First tighten the waterproof cover and then the sealing nut.
Step5
Use waterproof tape to wrap the joint between the waterproof cover and the cable.
