120
Parameters
username
:
Remote username for PPP authentication, a string of 1 to 80 characters.
Description
Use
dialer user
to add a remote username for authenticating incoming calls.
Use
undo dialer user
to remove the remote username.
By default, no remote username is set.
This command is only valid on dialer interfaces in RS-DCC.
On a dialer interface encapsulated with PPP, DCC identifies which dialer interface is to be used for
receiving calls based on the remote username obtained through PPP authentication.
You may configure multiple dialer users (up to 255) on a dialer interface. This allows DCC to provide
accesses to multiple dialup interfaces by using one dialer interface.
Use this command on a C-DCC enabled dialer interface with caution. It enables RS-DCC and can
remove the C-DCC configurations on the interface.
Performing the
undo dialer user
command on a dialer interface can clear all configurations on it.
Related commands:
ppp pap local-user
and
ppp chap user
.
Examples
# Add a remote username
routerb
.
<Sysname> system-view
[Sysname] interface dialer 1
[Sysname-Dialer1] dialer user routerb
dialer-group
Syntax
dialer-group
group-number
undo dialer-group
View
Dialup interface (dialer interface) view
Default level
2: System level
Parameters
group-number
:
Number of a dialer access group, in the range of 1 to 255. You may define it with the
dialer-rule
command.
Description
Use
dialer-group
to assign the interface to a dialer access group.
Use
undo dialer-group
to remove the interface from the dialer access group.
A DCC dialup interface can belong to only one dialer access group. Configuring this command can
overwrite the previous dialer access group setting for the interface, if any.
