H3C SR8800-F, Руководство по установке

Страница: 42 / 148

18
2. Remove the dust plug from the target fiber port.
3. As shown in Figure 19 , correctly orient the transceiver module and align it with the fiber port.
Push it gently into the port until you feel it snaps into place.
Transceiver modules and fiber ports have disorientation rejection designs. If you cannot insert a
transceiver module easily into a port, the orientation might be wrong. Remove and reorient the
transceiver module.
In case of limited space, you can gently push against the front face of the transceiver module
instead of the two sides.
4. Fasten the captive screws on the transceiver module to secure it in place.
If a screw cannot be fastened, adjust the CFP module and the screw and re-fasten the screw, or
remove the CFP module and then reinstall it.
5. Connect a fiber to the module. For the installation procedure, see "Connecting the router to the
network."
Figure 19 Installing a CFP transceiver module
Connecting an E1 cable
1. Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
For more information, see " Attaching an ESD wrist strap ."
2. Connect the HD96 connector of the E1 cable to the interface on the subcard and use a
screwdriver to fasten the screws on the connector.
3. Connect the other end of the E1 cable to the peer device.
Figure 20 Installing an E1 cable
1
2
2
1
2
2