H3C SR8800-F, Руководство по установке, Страница: 30 / 148

6
1. Wear an ESD wrist strap and make sure it has a good skin contact and is reliably grounded. For
more information, see "
Attaching an ESD wrist strap ."
2. Remove the filler panel (if any) from the target slot.
Keep the filler panel secure for future use.
3. Unpack the power supply, and verify that the model is correct.
4. Insert the power supply with its upside up into the slot:
a. Grasp the handle of the module with one hand and support the module bottom with the
other.
b. Gently push the power supply along the guide rails into the slot to firmly seat it into the
backplane, as shown by callout 1 in
Figure 5 .
When a misalignment occurs, pull out the power supply first, and push it in again to avoid
damage to the power supply and the connection terminals on the backplane.
5. Fasten the captive screws on the power supply to secure the power supply into the chassis, as
shown by callout 2 in
Figure 5 .
If the captive screws cannot be fastened tightly, do not fasten them forcibly. Check the power
supply installation.
Figure 5 Installing a power supply (PSR1400-D)
Connecting the power cord
WARNING!
Before connecting the power cord for a power supply, make sure the switch on the power supply is
turned off.
1
2
2