331
Configuring the portal authentication server on IMC PLAT 3.20
In this example, the portal server runs on IMC PLAT 3.20-R2602P13 and IMC UAM 3.60-E6301.
1.
Configure the portal authentication server:
a.
Log in to IMC and click the
Service
tab.
b.
Select
Access Service
>
Portal Service Management
>
Server
from the navigation tree
to open the portal server configuration page, as shown in
c.
Configure the portal server parameters as needed.
This example uses the default values.
d.
Click
OK
.
Figure 100 Portal authentication server configuration
2.
Configure the IP address group:
a.
Select
Access Service
>
Portal Service Management
>
IP Group
from the navigation
tree to open the portal IP address group configuration page.
b.
Click
Add
.
c.
Enter the IP group name.
d.
Enter the start IP address and end IP address of the IP group.
Make sure the host IP address (2.2.2.2) is in the IP group.
e.
Select a service group.
This example uses the default group
Ungrouped
.
f.
Select
Normal
from the
Action
list.
g.
Click
OK
.
Figure 101 Adding an IP address group
3.
Add a portal device:
