3-12
Use the PGND cable provided with the switch to connect the grounding strip in the equipment room.
Otherwise, the grounding effect may not be ensured, which easily causes damage to the switch.
Installing a Power Module
The S5800-60C-PWR/S5800-32F provides two power module slots on its rear panel. Hot swappable
power module slot 1 is empty when the switch is shipped, and hot swappable power module 2 is
installed with a filler panel. You can select one or two power modules for your switch as needed. For
details about optional power modules, refer to
Hot Swappable Power Modules
on page
1-23
.
This section describes how to install and remove the power module and the power cord. To prevent
damage to the device and personal injury, follow the installation and removal procedures illustrated in
Figure 3-17
and
Figure 3-18
, respectively.
Figure 3-17
Installation procedure
Install the
power module
Connect the
power cord
Switch on the
power module
Install the
power module
Connect the
power cord
Switch on the
power module
Figure 3-18
Removal procedure
Switch off the
power module
Disconnect the
power cord
Remove the
power module
Switch off the
power module
Disconnect the
power cord
Remove the
power module
Installing the Power Module
The procedures of installing any type of hot-swappable power module into the S5800-60C-PWR and
S5800-32F are similar. The installation procedure is as follows:
Step1
Wear an ESD-preventive wrist strap, ensure a good skin contact and make sure that the
ESD-preventive wrist strap is properly grounded.
Step2
Before installing the PSR750-A or PSR750-D to the S5800-60C-PWR, remove the blank filler module
on the rear panel of the switch (see callout 1 and callout 2 in
Figure 3-19
).
Step3
Take the power module from the package and check that the power module model is as required.
Step4
Face the slot into which the power module is to be inserted.
Step5
Insert the power module with the upside up. Grasp the handle of the module with one hand and hold the
module bottom with the other, and then slide the module slowly along the guide rails into the slot (see
callout 1 in
Figure 3-20
or
Figure 3-21
).
Step6
Fasten the captive screw on the power module clockwise with a Philips screwdriver until the power
module is fixed into the chassis (see callout 2 in
Figure 3-20
or
Figure 3-21
).
